Built with the same rigid standard that has made RENS metal detectors one of the most durable and reliable units in the field today. Backed by more than 50 years of experience, design and service.
RENS model P-4000 is a fully automated unit. No manual adjustments are required. Simply turn on and let it work as hard as you do. Runs ten hours on a full charge. Regulated power prevents loss of sensitivity as battery charge is depleted.
This unit is designed to be used in an industrial environment without needing a lot of operator skill.
Two Year Warranty-Parts & Labor
P-4000 Poly-Form Carrying Case
Protective Case & Chassis
The above items can not be detected at distances farther away than shown in the above chart.
Suggested method of scanning logs
This procedure will insure that the entire surface of the log is scanned by the metal detector.
NOTE: The surface (ground, deck, concrete floor) must be free of metal in order not to interfere with electromagnetic field of the search head.
1. Place search head close to the log surface and scan the entire length of the log as shown in diagram to left.
2. Move to other side of the log and repeat step 1.
3. Roll log over as required to expose unscanned surfaces. Scan the rest of the circumference of the log covering the complete surface of the log. Overlap longitudinal sweeps to prevent dead spots.
| About RENS |
Proposal Forms |
| Standard Under Conveyor System | High Powered Under Conveyor System |
| Whole Log System | Fiberglass Sections |
| RENS' Home Page |
RENS Metal Detectors, A Division of Lacey-Harmer Co.
4270 NW YEON AVENUE Portland, OR 97210
FAX: (503) 222-0073